Perfax Wallpaper Adhesive for Vinyl, Textile and Glassfibre

Perfax Wallpaper Adhesive for Vinyl, Textile and Glassfibre

Application and use

Perfax Vinyl, Textile & Glassfibre adhesive is suitable for bonding vinyl wall coverings with textile or fleece backing, jute and glassfibre. It can be applied to absorbent surfaces such as plaster, concrete, gypsum and wood.

Not suitable for non-absorbent surfaces or for use in Perfax wallpaper pasting machines.

Consumption and properties

Consumption is approximately 150–200 g per m², depending on the surface and the type of wall covering.
The adhesive has an open time of approximately 20–30 minutes, allowing sufficient time for corrections during application.

The adhesive is:
– Solvent-free
– Moisture-resistant
– Dries transparent
– Easy to reposition

Surface and adhesive preparation

The surface must be firm, permanently dry, clean and free of dust and grease. Fill cracks and holes beforehand using a suitable filler. Highly absorbent surfaces should be pre-treated with diluted Perfax Vinyl & Textile adhesive (add approximately 20% water).

Stir the adhesive thoroughly before use.

Application method

Apply the adhesive evenly to the surface using a glue roller, short-haired brush or notched trowel. Apply the wall covering into the wet adhesive and press firmly. Always follow the instructions provided by the wallpaper manufacturer.

Cleaning and important notes

Remove adhesive residues immediately with a damp cloth. Clean tools with water immediately after use. Close the container tightly after use.

Do not apply at temperatures below +5 °C.
Non-flammable, but sensitive to frost.

Decoration practical tip

Use this adhesive for heavier wall coverings where calm, even application is essential. The longer open time allows controlled working, which clearly improves the final result with textile wallpaper and glassfibre.

FAQ

1. Which types of wallpaper is this adhesive suitable for?
Vinyl wallpaper, textile wallpaper, jute and glassfibre.

2. On which surfaces can this adhesive be used?
On all absorbent surfaces such as plaster, concrete, gypsum and wood.

3. How much adhesive do I need per m²?
Approximately 150–200 grams per m².

4. Does the adhesive dry visibly?
No, it dries transparent.

5. Can adjustments be made during application?
Yes, the open time of around 20–30 minutes allows repositioning.